2007 Mustang GT
By: Harry Mager | 07.27.2010 | 20:11:57 | Views: 6287
I set out to build the Ultimate Sleeper..quiet at idle...stock looks Thanks to M&H Tires for the free set of Drag Radials I won on their site!!! Just Awesome!

www.MandHtires.com Their Forum for the contest www.TheFoat.com And their friends at www.SpeedSceneRacing.com I was on their Live TV show Tuesday 5-4-2010 Here is a link to the show video taping. I was 7:08 into the taping and done at 10:45 into it.

http://speedsceneracing.com/video/SpeedSceneVideo5-4-10.wmv

Video of my 10.73 @ 128mph 1/4 mile run http://www.youtube.com/watch?v=TKrB5TGe15Q Another New Video (Walk Around) in HD 1080p 5-16-2010 http://www.youtube.com/watch?v=kvDOpAs_E9o
My 2007 Mustang GT Premiem Coupe I purchased this car brand new off the showroom floor.
Stock Equipment | Torch Red/Parchment Leather Interior
4.6 Liter 3v V8 w/300hp | 5 speed Automatic | 3.31:1 Limited Slip Rear
Still stock 4.6 litre 3valve V8 motor(281 cu. in.) Purchased New 1-12-2008 3,000 miles so far (9-19-2008)
4,200 miles so far (3-10-2010)

List of Mods below

Special Thanks to Saleen Speedlab, Team JDM, BadMC and Ford!
www.Saleen.com
www.TeamJDM.com
www.BadMustangsclub.com

Tuned by www.TeamJDM.com - (Jim D'Amore) using SCT software

Mods I added ...

Saleen Supercharger, 3.00 blower pulley (13 lbs of boost/487 rwhp.)

4.10 gears, Kooks Longtube Headers/Catted X pipe, Ford Racing 5235-SGT Mufflers,

60 lb injectors, Saleen Ultimate Air Intake and 95mm Massair, GT500 Fuel Pumps,

JDM Automatic Trans Fluid Overflow Catch Can, Leonard Racing Spyder 1 piece Aluminum Driveshaft,

Metco Drive Shaft loop, ICM lower rear control arm brackets, BMR rear springs to even out the cars stance.

A few photos of my car being used for the Muscle Mustangs & Fast Fords Magazine Christmas Photo shoot for the Jan 09 Issue.

....

Published in section(s): Favorite Vehicles ::